Cable Assembly

SFF-8643 to 4 × SATA breakout cable

Part No.RHT-726-3007

Connect one internal Mini-SAS HD port to four individual SATA data connections.

  • One-to-four breakout1 × SFF-8643 to 4 × SATA 7-pin ends.
  • Labeled branches with metal latchesP1–P4 branch labels and metal SATA latches.
  • 500 ±20 mm drawing lengthCheck the dimension reference points in R1.0.

Check controller SATA support and breakout wiring. Drive power is supplied separately.

Include quantity, mating equipment and installation requirements.

Product data

The connection, at a glance.

Check the documents ↗

Connection

Connector Type
Mini-SAS HD / SATA
Connector A
Mini-SAS HD SFF-8643
Connector B
SATA
Connector A quantity
1
Connector B quantity
4

Mechanical

Drawing length dimension
500 ±20 mm
Branch identification
P1, P2, P3, P4
SATA retention
Metal latches

Engineering resources

Check fit and wiring.

1 product document

Before you specify

Selection guide

Connection schematic: one SATA-capable SFF-8643 controller port connects to four SATA drive data ports, with separate drive power
Connection schematic. Refer to the engineering drawing for pin assignments.

For an SFF-8643 host port and individual SATA drives

The published wiring is consistent with a forward breakout configuration. Verify that the controller supports SATA drives on the selected port.

01

Confirm the direction

Four motherboard SATA ports to an SFF-8643 backplane require a different, reverse breakout configuration.

02

Check protocol and drive power

An SFF-8643 connector does not identify the protocol by itself. A PCIe/NVMe port needs the corresponding cable. Supply each drive with power separately.

03

Measure the cable route

Check the 500 ±20 mm drawing dimension against the route to each drive, including bends and latch access.

RHT-726-3007

Ready to specify your connection?

Share the equipment, dimensions and quantity you need.

Request a quote

Connector requirement

Request a quote

Share your connector requirements and the specifications you need.

    Inquiry details

    Attach one PDF, JPEG or PNG, up to 5 MB.

    Include the details needed to help with your connector inquiry. You can check them before sending.

    Complete verification before sending.